Back to Product
Installation

Installation and Mechanical Setup Guidelines

Proper installation of the CAME BK-BKE 2200 electromechanical sliding gate operator is essential to ensure reliable long-term automation for industrial entrances, multi-leaf telescopic gates, and heavy commercial access points rated up to 2200 kg. Field technicians must complete all foundation, mechanical alignment, and electrical termination procedures according to the manufacturer technical specifications.

Foundation and Baseplate Mounting

The 21 kg gearmotor requires a rigid, level concrete foundation poured directly adjacent to the ground sliding track. Corrugated conduit must be routed through the foundation pad to supply 230 V AC line power and auxiliary control cabling before the concrete cures.

Secure the operator baseplate to the concrete using high-tensile anchor bolts or concrete expansion anchors. Ensure the baseplate is positioned perfectly parallel to the gate rail. The cast aluminium chassis of the BK-BKE 2200 sits directly on this baseplate and is secured with mounting bolts that allow minor lateral leveling and position adjustments.

Pinion Clearance and Module 6 Rack Meshing

The BK-BKE 2200 features a module 6 (M6) drive pinion engineered to mesh with heavy-gauge 30 x 30 mm galvanised steel toothed racks (such as CAME part 009CGZ6). Correct mechanical clearance is paramount to prevent premature drive wear:

  • Tooth Pitch Clearance: Maintain a strict clearance of 1 mm to 2 mm between the tips of the pinion teeth and the root of the rack teeth across the entire travel span.
  • Load Isolation: Never permit the physical weight of the gate leaf (up to 2200 kg) to rest upon the drive pinion or motor shaft. The entire vertical mass must be borne exclusively by the ground track and roller assemblies.
  • Uniform Mesh: Weld or bolt rack sections along the gate leaf structure in straight alignment to ensure seamless engagement with the M6 pinion along full travel at speeds up to 10.5 meters per minute.

Limit Switch Setup and Manual Release Disengagement

The unit incorporates mechanical limit switches (with optional support for magnetic limit switches) to define the gate's open and closed deceleration and stopping positions. Secure the mechanical limit switch striker fins onto the gear rack at each terminal limit, adjusting their positions so the spring-loaded actuator arm trips prior to physical contact with mechanical end stops.

For commissioning or emergency operation during power outages, use the key-operated manual release hatch on the gearmotor housing. Opening the hatch disengages the non-reversible electromechanical reduction unit, allowing manual leaf movement.

Electrical Termination and Safety Device Integration

Remove the ABS protective cover to access the integrated CAME control board (ZBKN/ZBKE series). All line and low-voltage wiring must comply with standard industrial site safety practices:

Terminal / ParameterSpecificationInstallation Function
Primary Power230 V AC, 50/60 HzMains electrical feed (580 W rated power, 5.1 A absorption)
Line Protection8 A-F quick-acting fuseHigh-voltage board and motor line protection
Auxiliary Power1 A-F quick-acting fuse24 V AC/DC accessory circuits and sensor loops
Safety InputsResistive 8.2 kΩConnection for sensitive safety edges to meet EN 12453
Accessory SlotsCAME AF connectorPlug-in radio card for remote transmitter decoding
Optical SafetyInfrared photocell pairsThrough-beam safety reversing circuit integration

Verify that all conduit entry points into the IP44-rated cast aluminium chassis are sealed against dust and moisture before powering the 1500 N thrust operator.