Optical Sensor Verification and Biometric Identification Errors
The eSSL X990 operates using a 500 DPI optical fingerprint sensor running Algorithm Version 10, engineered for an identification speed of under 0.5 seconds with a False Acceptance Rate (FAR) ≤ 0.0001% and a False Rejection Rate (FRR) ≤ 1%. If the terminal regularly exhibits repeated read failures or higher-than-normal false rejection rates, evaluate the surface condition of the optical prism.
Accumulation of ambient dust, sweat, or grease residues on the prism face distorts image capture. Clean the optical sensor window using a clean, soft, lint-free microfibre cloth without deploying abrasive chemical cleaners. In industrial environments where user fingertips are excessively dry, cracked, or soiled with process grime, guide personnel to register alternate fingers or utilize RFID card authentication (supporting up to 10,000 cards) or numeric PIN access via the physical keypad.
TCP/IP Network Connectivity and Push Data Synchronization Faults
When transaction logs fail to transfer automatically to the central management platform (such as eTimeTrackLite desktop or web versions, or third-party HRMS/Payroll/ERP software), inspect the push data communication parameters:
- Network Addressing: Confirm that the terminal's assigned static IP address, subnet mask, and default gateway match local area network routing specifications via the 3-inch Color TFT interface.
- Server and Port Configuration: Verify that the target server address (configured either as a static IP or domain server) and communication port match the listening settings on the push data server manager.
- Log Buffer Management: The internal memory stores up to 100,000 transaction logs. If local network disruptions prevent automated synchronization, download records immediately onto a FAT32-formatted USB flash drive using the onboard USB host port to avoid transactional overwrites.
12V Relay and Access Control Peripheral Troubleshooting
The integrated 12V relay interfaces directly with electromagnetic (EM) locks, bolt locks, and strike locks. If an authenticated user triggers a green status LED indication on the front panel and an audible prompt from the mini speaker, but the lock fails to disengage, inspect the peripheral connections:
- Relay Line Continuity: Verify that the 12V relay terminal output maintains proper circuit continuity and polarity to the attached lock mechanism.
- Fire Alarm and Door Sensor Inputs: Confirm that the fire alarm trip input is not held in an open circuit state, which forces an override state, and ensure door sensor inputs report correct open/closed status.
- Anti-Passback Locks: If anti-passback is enabled, verify that entry and exit reader sequences are followed. When users attempt successive entries without an exit record, the terminal suppresses relay activation.
- Exit Reader Signals: When connecting external exit devices such as the 101 HE, FR 1200, KR500, KR503, or touchless sensors, check that signal polarity and Wiegand wiring match. Ensure that Wiegand In/Out format selection is configured identically (26-bit or 34-bit, with or without site code).
Power Supply and System Boot Diagnostics
The eSSL X990 requires a dedicated power input of DC 12V at 1.5A. Power fluctuations, undersized wiring runs, or insufficient current cause unexpected system reboots, TFT display flickering, or optical sensor initialization failures during peak draw when relays trip. Measure terminal block voltage with a multimeter under full operating load. Where the optional internal battery backup (they are not included) is fitted, ensure proper terminal connection and charging continuity. Verify operating ambient conditions remain strictly within 0°C to 45°C and 20% to 80% non-condensing humidity to protect the 32-bit microprocessor, 128 MB Nand Flash SDRAM, and 256 MB Nand Flash memory running the Linux 2.6 kernel.