Mounting Specifications and Environmental Parameters
The eSSL VEGA+W+POE terminal features physical dimensions of 205.7 mm (L) x 82.7 mm (W) x 33 mm (H). Physical installation must ensure accessible placement to allow ergonomic operation of the 2.4-inch TFT color LCD screen (240 x 320 resolution), the 17-key physical keypad, and the biometric optical sensor.
The unit carries an IP65 ingress protection rating, making it suitable for environments prone to dust exposure and water ingress. Installers must confirm that site conditions conform to the specified operating temperature range of -10°C to 55°C and an operating relative humidity threshold of 10% to 90% RH (non-condensing).
Power Supply Configuration: PoE and DC 12V
The terminal provides dual power delivery options to accommodate varied network and electrical infrastructures:
- Power over Ethernet (PoE): Complies with IEEE 802.3 standard PoE. Utilizing an IEEE 802.3 compliant Ethernet drop allows simultaneous network data communication and terminal operating power delivery over a single Category cable, eliminating the requirement for a separate low-voltage power supply at the door.
- External DC Power: Accepts an external regulated DC 12V, 1.5A power connection at the designated terminal blocks. Observe correct terminal polarity when landing DC power leads.
Access Control Interface and Peripheral Wiring
The VEGA+W+POE incorporates direct onboard terminal blocks to drive locking mechanisms and monitor peripheral door hardware:
- Lock Relays: Dry relay terminals support connections to an Electro Magnetic Lock (fail-safe) or an Electric Lock / strike (fail-secure).
- Door Sensor: Input terminals connect to a magnetic door contact to monitor door status and detect unauthorized entry or door-ajar conditions.
- Exit Button: Dedicated input terminals accept dry contact signals from a push-to-exit button located on the interior side of the secure threshold.
- Alarm Output: Auxiliary relay output terminals allow integration with external alarm sounders, indicators, or building security monitoring systems.
Wiegand Interface Configuration
The hardware includes a software-configurable Wiegand interface that can be assigned to operate in either of two modes:
- Wiegand Input: Allows wiring an external secondary reader (such as a 125 kHz proximity card reader or 13.56 MHz Mifare card reader) to the terminal for dual-direction access control.
- Wiegand Output: Outputs authenticated credential data (from fingerprint, RFID card, or 6 to 8 digit user keypad passwords) to an external third-party access control control panel.
Network Infrastructure and Data Communication
To enable template distribution (up to 3,000 users, 3,000 fingerprints, and 3,000 cards) and retrieve stored event records (up to 200,000 transactions) managed by the embedded Linux operating system, connect the terminal via one of the available interfaces:
- TCP/IP Ethernet: Standard RJ45 port for wired local area network communication and IEEE 802.3 PoE power delivery.
- Wi-Fi: Wireless network integration for locations lacking structural data cabling.
- RS485: Serial bus interface for industrial networking and peripheral linking.
- USB Port: Physical USB host interface for offline data synchronization and manual log export via portable USB flash media.
Operational Checkout
Prior to finalizing terminal mounting, verify audio prompt functionality from the integrated 8 ohm ± 15% @ 1.0 W speaker, confirm credential verification performance (authentication speed under 0.5 seconds), and validate relay activation against the door locking hardware.