Mechanical Surface Mounting and Placement
The Onetouch OT-IP-VDP-C3 SIP video door station is engineered for surface wall mount installation at exterior or interior perimeter entry points. The compact enclosure measures 146 mm in height, 70 mm in width, and 23 mm in depth. When positioning the unit, system integrators must account for the 2-megapixel 1/2.7-inch CMOS camera optics, which provide a wide viewing angle of 125 degrees horizontal and 69 degrees vertical.
Mount the station at an ergonomic height that allows the built-in ambient light sensor, backlit call button, and integrated motion sensor to operate without physical obstruction. Ensure that the wall surface is flat and level to ensure that the rear vandal tamper alarm switch engages properly against the mounting plane. The unit is rated IP65 under IEC 60529 for dust and water ingress protection and operates reliably in ambient environments ranging from -10°C to +55°C. Care must be taken during mounting to verify that all rear cable pass-throughs and perimeter seals remain intact to preserve the IP65 environmental seal.
Power Delivery and Network Cabling
The station provides two flexible operating power pathways depending on infrastructure availability:
- Power over Ethernet (PoE): Compliant with the IEEE 802.3af standard, allowing single-cable delivery of system operating power and 10/100 Mbps data via a structured Cat5e or Cat6 Ethernet drop terminating at the RJ45 LAN port. An active IEEE 802.3af compliant network switch or active injector is required; passive PoE injectors must not be used.
- Direct DC Power Input: A dedicated 12V DC input terminal is provided for installations utilizing local or central auxiliary power supplies rather than PoE.
- Wireless Network Support: While primary communication runs across the 10/100 Mbps hardwired interface, optional wireless network capability is supported for flexible data routing.
Relay Terminals, Lock Integration, and Wiegand Wiring
The unit features multiple onboard terminal interfaces to support door access hardware and peripheral security integration directly at the door frame:
- Electric Door Lock Relays: Equipped with an onboard relay port architecture providing 2 relay inputs and 1 relay output. The output relay wires directly to electric strikes, electromagnetic locks, or automatic door operators. Lock activation commands are triggered locally via credential scan or remotely across SIP sessions using individual DTMF tone commands.
- Wiegand Interface: Incorporates 1 standard Wiegand port to output credential data from the integrated 13.56 MHz Mifare RFID reader and Bluetooth Low Energy (BLE) proximity scanner directly into third-party access control panels and controllers.
Commissioning and Interface Verification
Prior to completing the enclosure assembly, install a Micro SD card into the internal slot if onboard storage of visitor event images and video logs is required. Once connected to the local network switch, verify SIP v2.0 endpoint registration with the target SIP server, indoor console station, or Onetouch SmartCloud AI platform. Confirm that full duplex audio transmission (supported across standard audio codecs codecs) operates clearly with echo cancellation active, and test the front white LED array in low-light conditions to ensure automated night illumination triggers correctly.
