Back to Product
Installation

Installation and Anchoring Guide for KTI RBAS 75 mm Rubber Speed Breakers

Modular Layout and Road Surface Preparation

Proper installation of the KTI RBAS modular speed breaker begins with surveying the road cross-section at designated traffic calming points. Each modular unit measures 500 mm in length, 400 mm in width, and 75 mm in height, requiring two individual modules per linear meter of roadway coverage. Two sections combined yield an approximate weight of 24 kg to 24.5 kg per linear meter, providing substantial mass during alignment.

Before securing sections to the road, the installation footprint must be swept clear of dirt, loose aggregates, and moisture. Modular segments should be dry-fitted end-to-end across the traffic lane in an alternating black and yellow color scheme. This contrasting pattern maximizes visual conspicuity for incoming drivers across industrial sites, construction projects, residential societies, commercial malls, and hotel access drives.

Anchoring via Bonded Metal Washer Grooves

Each 500 mm RBAS module is engineered with four metal washer bonded grooves configured to receive heavy-duty fixing anchor bolts. These bonded internal washers reinforce the carbon black mixed rubber and LDPE composite structure, preventing bolt heads from pulling through or tearing the polymer rubberized compound under continuous dynamic wheel loading.

  • Marking Anchor Locations: Lay the alternating black and yellow sections in precise alignment across the driveway. Use the four bonded washer grooves in each section as direct drilling templates to mark fixing points onto the road surface.
  • Substrate Drilling: Shift the modules aside to drill pilot holes into the asphalt or concrete road foundation according to the bolt depth requirements. Clear all drilling dust and debris from the holes to ensure clean mechanical engagement.
  • Securing Fixing Bolts: Reposition the modular sections over the drilled holes, insert fixing bolts through the four metal washer bonded grooves, and torque them down until the speed breaker is anchored flush against the road bed.

Drainage Alignment and Reflective Tape Orientation

During section placement, installation teams must verify the correct direction of the molded drainage and visibility features. The RBAS unit incorporates a specialized grooved surface pattern engineered to facilitate rainwater drainage and maintain vehicle traction across the 400 mm width. Ensuring these grooves remain unobstructed prevents standing water accumulation along facility driveways.

Furthermore, each modular block is equipped with reflective arrow tapes designed to enhance night-time visibility. When fastening units to the road, verify that the reflective arrow tapes point directly toward oncoming traffic lanes. This directional orientation gives approaching drivers advance optical warning, which is especially critical in poorly illuminated access points.

Check Post and Main Gate Positioning

The 75 mm height profile of the RBAS speed breaker is specifically engineered to decelerate vehicles at critical facility perimeters. For maximum site protection, anchor modules across entry and exit lanes immediately preceding security check posts, boom barrier gates, and factory access barriers. Positioned properly, the speed breaker forces negligent and over-speeding vehicles to slow down, preventing costly impact damage to security gates and perimeter infrastructure.