Pre-Installation and Mounting Preparation
The KTI KTI16029002ESLG is a single-aspect, 200mm round green traffic signal light engineered with a durable polycarbonate housing. Because the light unit is supplied without poles, installation planning requires preparing dedicated mounting uprights, brackets, or mast arms matched to the specific site application, such as toll lanes, parking plazas, boom barrier islands, or industrial weighbridges.
Before fixing the polycarbonate housing in place, ensure the mounting structure is plumb, vibration-free, and rigid enough to support the 200mm round optical aspect. Position the single light unit at a height and line-of-sight angle that maximizes visibility for approaching vehicle operators, especially in automated gate and lane-control environments.
Electrical Specifications and Wiring Configuration
The signal unit operates on low-voltage direct current (12V DC or 24V DC). Direct wiring must be carried out using properly rated, insulated conductors routed through sealed conduit entry points to preserve the integrity of the polycarbonate enclosure.
- Supply Voltage Verification: Confirm that the power supply or auxiliary controller output provides a regulated 12V DC or 24V DC feed prior to terminating conductors.
- Polarity Connection: Connect the positive (+) and negative (-) DC supply leads directly to the designated power input terminals on the signal light module.
- Direct Controller Cabling: When operating via an automated access controller or solid-state traffic logic unit, route the DC control lines directly through switching relays or solid-state output cards.
Integration with Automation and Access Control Systems
The KTI16029002ESLG is built for seamless integration into low-voltage industrial automation architectures, automated parking networks, and security barriers. It interfaces reliably with standard auxiliary relays, vehicle inductive loop detectors, and solid-state traffic controllers.
| Target System | Interfacing Method | Functional Role |
|---|---|---|
| Automatic Boom Barrier | Auxiliary limit switch or barrier control board relay (12V/24V DC output) | Illuminates green when the barrier arm reaches the fully raised position. |
| Inductive Loop Detector | Presence relay output linked through 12V/24V DC switching circuit | Provides visual clearance indication once vehicle presence and authorization are validated. |
| Industrial Weighbridge System | Weighbridge management software / PLC digital DC output | Signals vehicles to proceed off the scale deck after weighing sequence completion. |
| Solid-State Traffic Controller | Dedicated 12V/24V DC lane-switching channels | Provides scheduled or triggered green aspect lane management. |
Commissioning and Functional Verification
Once mechanical installation and electrical wiring are complete, perform a systematic commissioning sequence:
- Energize the 12V/24V DC auxiliary power circuit and verify that the 200mm green aspect illuminates fully with uniform lens diffusion across the round profile.
- Trigger integrated access peripherals (such as boom barrier open commands, RFID badge readers, or loop detectors) to confirm that the green signal illuminates and turns off in exact synchronization with automated control logic.
- Inspect all cable entries, cable glands, and housing fasteners on the polycarbonate body to verify that the unit is securely sealed against environmental ingress.
