Pre-Installation Site Selection and Environmental Guidelines
The eSSL SilkBio-101TC is engineered exclusively for indoor installation. To ensure optical recognition accuracy and prevent sensor interference, locate the terminal at least 10 feet (3 m) away from exterior windows and at least 6.5 feet (2 m) away from overhead light fixtures. Avoid positioning the device facing direct sunlight, reflective surfaces, or excessive optical glare, as ambient lighting extremes compromise the integrated camera and infrared illumination detection. Verify that the operating environment conforms strictly to the specified operational range of 0°C to 45°C ambient temperature and a non-condensing relative humidity of 20% to 80%.
Mounting Height and Spatial Alignment
Accurate baseline height selection is critical to accommodate user facial enrollment and multi-biometric verification within the recommended 0.5-meter standoff distance between the subject and the terminal camera.
| Mounting Baseline Height (Ground to Plate Baseline) | Target User Height Range | Recommended Subject-to-Device Distance |
|---|---|---|
| 1.1 meters (Recommended standard) | 1.55 m to 1.85 m | 0.5 meters |
| 1.2 meters (Elevated setup) | Greater than 1.65 m | 0.5 meters |
Ensure that enrolled personnel maintain identical distance and facial posture during regular verification passes as established during primary enrollment.
Mechanical Wall-Mounting Procedure
The physical unit measures 180 mm in length, 154 mm in width, and 34.2 mm in thickness. Follow these step-by-step mechanical mounting instructions to secure the device:
- Step 1 — Template Placement: Align the mounting plate against the vertical wall surface at the calculated baseline height (1.1 m or 1.2 m from finished floor level) and mark the designated drill holes.
- Step 2 — Anchoring: Drill fixing holes into the substrate, insert wall expansion plugs, and firmly fasten the backplate to the wall using the supplied fixing screws.
- Step 3 — Cable Routing: Route all incoming wiring harnesses—including power, access control signals, and network leads—through the central cable opening in the mounting backplate.
- Step 4 — Device Attachment: Align the rear mounting slots of the terminal over the upper hooks of the backplate, slide the unit downward firmly until seated flush against the plate, and verify that the rear spring-loaded tamper switch is fully depressed.
- Step 5 — Bottom Screw Fastening: Secure the unit mechanically by driving the bottom fixing screw into the base of the terminal chassis to prevent dislodgement.
Rear Terminal Wiring and Power Configuration
All hardware interfaces are accessible via dedicated rear-panel ports. Complete wiring before final attachment to the backplate:
- Primary Power Supply: Terminate a regulated DC 12V, 1.5A external power adapter to the rear DC power port.
- Internal Backup Battery Activation: The unit includes a built-in 2000mAh backup battery. Activate internal battery backup operation by sliding the rear battery switch to the left. To isolate and power off the internal battery circuit during storage or transit, slide the switch to the right.
- Peripheral Access Control Interfaces: Connect the dedicated connection ports to third-party access control peripherals, including electric door locks, door status sensors, exit push buttons, and external alarm systems or external bells.
- Tamper Alarm Switch: The terminal features a mechanical spring-loaded tamper alarm switch on the back panel. When properly mounted against a flat wall, the switch remains compressed. If the device is detached or pried from the mounting backplate, the switch pops outward, sounding an acoustic local alarm and displaying an alert icon on the 2.8-inch TFT screen status bar.
- System Reset: A hardware reset button is located on the rear interface panel for hardware-level reboots if required during maintenance.
Network Integration and Commissioning
Connect the terminal to local infrastructure via the integrated RJ-45 TCP/IP Ethernet port or through Wi-Fi connectivity. Data can also be exported or loaded offline using a USB drive via the USB-Host port. Once connected, configure communication parameters to enable Push Data transmission to central management servers and eTimeTracklite software platforms for real-time transaction synchronization.