Physical Mounting and Environmental Requirements
The eSSL MB20 biometric terminal is engineered for wall-mounted installation in commercial, institutional, and industrial facilities. When selecting the mounting location, ensure the site aligns with the device's operational threshold of 0°C to 45°C and an ambient operating humidity tolerance between 20% and 80% RH (non-condensing). The unit features an enclosure footprint measuring 161.93 mm in width, 152.82 mm in height, and 30.59 mm in depth, with an overall net weight of 0.71 kg.
For optimal multi-biometric recognition, position the terminal on a rigid, vibration-free vertical surface at a height that allows the 2.8-inch color LCD display and optical sensors to align naturally with standing users. Adequate clearance should be maintained around the housing to facilitate clean conduit routing, rear-panel access, and unhindered maintenance of side-accessible ports such as the USB 2.0 host connection.
Power Supply Integration and Wiring
Electrical power must be delivered via an external, regulated DC 5V, 0.8A power adapter. Because this MB20 model is configured as a standard terminal without an internal built-in battery, stable and uninterrupted line power is critical to avoid system drops during active operational cycles. Where installation sites experience periodic line power fluctuations, an optional external 5V 1900mAh UPS battery (they are not included) may be integrated into the DC feed to provide up to 3 hours of standby backup operation.
Ensure power cable runs observe correct polarity prior to energizing the unit. Excessive cable lengths should be avoided to prevent voltage drops below the 5V operational threshold, which could otherwise affect sensor accuracy or interface responsiveness.
Access Control Terminal Connections
The eSSL MB20 features dedicated peripheral terminals designed to manage a single secure entryway. Integrators can hardwire the terminal directly into standard door hardware loops without requiring separate third-party relay boards for basic entry control:
- Electronic Door Lock: Connects to the terminal's onboard lock control interface to actuate electric strikes, electromagnetic locks, or drop-bolt mechanisms.
- Door Sensor: Links to door-position contacts to monitor door status and detect forced or unlatched entry states.
- Request-to-Exit Button: Interfaces with a standard egress button for exit authorization from the interior zone.
Network Infrastructure and Communication Deployment
The terminal integrates into existing local area networks (LAN) or wide area enterprise networks using its onboard TCP/IP Ethernet port. Install standard CAT5e or CAT6 network cabling terminating into the RJ45 port. The unit supports real-time push data protocol with rapid transmission speeds of 1 second or less (≤1 sec), routing transaction logs directly to centralized management servers.
In remote installations or standalone environments where structured network cabling is unavailable, transaction logs and user databases can be exported and imported offline using the built-in USB 2.0 Host port with a standard USB flash drive.
Post-Installation Testing and Commissioning
Once power, access peripherals, and network connections are secured, complete the following verification steps using the integrated 2.8-inch color LCD interface and onboard keypad:
- Audio-Visual Feedback: Confirm that the built-in stereo speaker emits audible confirmation prompts and that the 2.8-inch screen initializes the graphical interface.
- Data Input Configuration: Utilize the T9 keypad input to set system parameters, configure network IP addresses, adjust Daylight Saving Time (DST), and set the scheduled bell timings.
- User Enrollment: Enroll test credentials to verify multi-modal verification (face template capacity up to 200, fingerprint capacity up to 500, or 9-digit User IDs with password/RFID card modes).
- Lock Cycle Validation: Trigger an authorized authentication to confirm that the lock output triggers correctly, the door sensor registers state changes, and the exit button reliably releases the lock mechanism.