Substrate Preparation and Surface Requirements
Achieving maximum adhesion performance for the Knuffi Type AA corner protection profile depends entirely on correct substrate preparation. The factory-applied modified acrylic adhesive delivers an adhesion strength of 21 N / 25 mm, but it requires a clean, dry, dust-free, and thoroughly degreased surface. Contaminants such as industrial oils, grease, loose paint, powdery concrete dust, or residual moisture will prevent proper contact and lead to premature bond failure.
Before applying the bumper guard, clean the target 90-degree corner using an appropriate industrial degreasing solvent that leaves no residue. Allow the surface to dry completely. Knuffi Type AA is engineered to bond securely to smooth and degreased metals, painted surfaces, sealed masonry, structural plastics, and finished wood across indoor and outdoor operating environments ranging from -40 °C to +100 °C (-40 °F to +212 °F).
On-Site Sizing and Profile Cutting
Knuffi Type AA profiles—featuring an overall cross-section of 40 mm width by 36 mm depth with a 19 mm x 19 mm internal corner cutout—can be cut to exact project measurements on-site. Whether sourced in 1 m pre-cut lengths, 5 m rolls, or custom coils up to 50 m, cutting requires only standard site tools.
- Measure the vertical or horizontal edge of the target column, racking upright, or machinery frame.
- Mark the cut line precisely on the yellow and black reverse-printed protective outer polyurethane foil.
- Use a sharp utility knife to slice squarely through the flexible Shore A 40 polyurethane (PU) foam core and backing liner in a single, smooth pass to ensure clean, flush joint transitions.
Peel-and-Stick Mounting Sequence
The integrated light- and aging-resistant modified acrylic adhesive eliminates the need for mechanical fasteners, drilling, or secondary liquid glues on external 90-degree right-angle building corners, beams, and equipment profiles.
- Step 1: Alignment Test: Dry-fit the trimmed profile against the 90-degree corner to verify that the 19 mm x 19 mm internal cutout sits flush against both structural faces.
- Step 2: Liner Removal: Peel back approximately 100 mm to 150 mm of the protective backing liner from one end of the profile to expose the adhesive layer.
- Step 3: Initial Positioning: Position the profile starting at the top or leading edge of the structural corner, firmly pressing the exposed adhesive section against the substrate.
- Step 4: Continuous Application: Gradually pull the protective backing liner downward or along the edge while progressively pressing the bumper guard into place, ensuring the profile remains straight and centered on the 90-degree apex.
- Step 5: Final Pressure: Apply firm, uniform pressure along the entire length of the profile to activate the pressure-sensitive adhesive backing and eliminate trapped air pockets.
Installation Parameters Overview
| Parameter | Specification / Requirement |
|---|---|
| Profile Geometry | 40 mm (W) x 36 mm (D) with 19 mm x 19 mm 90° internal cutout |
| Substrate Compatibility | Clean, degreased metal, painted surfaces, sealed masonry, plastics, wood |
| Mounting System | Self-adhesive peel-and-stick backing (21 N / 25 mm adhesion rating) |
| Cutting Method | Standard sharp utility knife |
| Service Temperature | -40 °C to +100 °C (-40 °F to +212 °F) |